Dimplex repair manual

disconnect power and call Dimplex customer service at DImPLEX (). Remote Control. Remote Control Initialization Setup 1. Turn on the electrical power at the circuit breaker. 2. Slide open the battery cover on the back of the remote control. 3. Install three AAA batteries into the remote control. Re-place the battery cover. (Figure 2)! manual controls. Hold both Temp– () and Brightness (), on the unit, for 2 seconds to enable the manual controls. Resetting the Temperature Cutoff Switch Should the heater overheat, an automatic cut out will turn the heater off and it will not come back on without being reset. It.  · Dimplex Electric Fireplace, the heater and fan quit working. This is a step by step video on how to repair it.

2 www.doorway.ru Table of Contents. Always use a qualified technician or service agency to repair this fireplace.! NOTE: Procedures and techniques that are considered important enough to emphasize. CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNING: Procedures and. power at the service panel and have the heater inspected by a reputable electrician before reus-ing. ⑥ Do not operate any unit with a damaged cord or plug, or if the heater has malfunctioned, or if the electric fireplace has been dropped or damaged in any man-ner, contact Dimplex Technical Service at ⑦ Do not use outdoors. 1. Ensure that power is supplied through main service panel. 2. Access the manual controls, (remove the glass doors if applicable) pull the right hand steel curtain to the outside of the unit. 3. Locate manual controls. 4. Move the 3-position switch to “Remote”, on newer models only. 5. Activate the main power switch, the red Level 1.

Dimplex, Electralog and Contempra Fireplace Replacement Parts listed in either an Owners Manual, Service Manual, Parts List or Parts Manual. All Dimplex products come with accompanying instruction manuals or guides. If you have misplaced the manuals supplied with your product, please enter the. The fireplace has a manual power ON/OFF switch located on the lower right side to continuously reset the heater, unplug the unit and call Dimplex North.