Digitrace ngc-30 manual

DigiTrace NGC, the cost of RTD field wiring will be significantly reduced. The DigiTrace NGC system supports multiple communications ports, allowing serial interfaces (RS and RS) and network connections (Ethernet) to be used with external devices. All communications with the NGC panel are accomplishedMissing: manual. Page 4: Section 1 - Introduction. seCtion 1 – introduCtion rayChem nGC ProduCt oVerVieW This manual describes how both the Raychem NGC and Raychem NGC can be programmed via the User Interface Terminal (NGC-UIT2-EX). The Raychem NGC and Raychem NGC are part of the same family of www.doorway.rug: digitrace. NGC Multipoint heat-tracing control system Product Overview The DigiTrace NGC is a multi-circuit electronic control, monitoring and power distribution system for heat-tracing used in process-temperature maintenance and freeze-protection applications. The DigiTrace NGC File Size: 2MB.

The DigiTrace NGC also supports load-shedding. This mode overrides temperature control and forces the output of the control module off. The load-shedding command can be issued by Touch , Distributed Control System (DCS) or DigiTrace fault equipment protection on all heat trac Supervisor (DTS). Monitoring The DigiTrace NGC system measures. 6 NGC INSTALLATION MANUAL Area of use DigiTrace NGCC(L)-E controllers are used for temperature control and temperature limiting of electrical heaters in industrial and potentially explosive atmospheres. The DigiTrace NGCCL-E consists of a temperature controller and an additional safety temperature limiter. The DigiTrace NGC control unit is equipped with a RS interface. Through this interface up to DigiTrace NGC units can be networked to a single DigiTrace NGC-UIT or to one serial port of standard PC running Tyco Thermal Controls´ DigiTrace Supervisor software. The DigiTrace NGC control unit can as well be monitored and/or.

DIGITRACE*. NGC Control. Monitoring Raychem NGC is an advanced www.doorway.ru, or the one in the back of the installation manual. 2 V VPL must use DigiTrace , N, T or NGC controllers only.. Pre-Insulation Checks. Visually inspect the heating cable and components for. See the NGC Programming Guide (H) and the NGC Installation Manual (H) for additional details on setting up this type of connection.